Werbung
Verfügbare Sprachen
Verfügbare Sprachen
A PING-PONG RECORDING
EXAMPLE
Here's how the controls should be set:
«INPUT SELECT switches
Make sure that the channel 1,2 and 3 INPUT SELECT
switches
are set to TAPE and the channel-4
INPUT
SELECT switch is setto OFF.
«Input Faders
To begin with, set the input 1 through 3 faders to about
"7" on their scales, and set the MASTER fader to "0."
«REC SELECT Switches
The channel 1 through.3 REC SELECT тээн
must
be set to OFF, and the channel-4 REC SELECT switch
should be set to "В."
*
AUX SEND Controls
Set all four AUX
SEND
controls to MIN for the time
being.
¢ GRAPHIC EQUALIZER Switch
Switch this OFF for the time poing:
PAN Controls
|
Since the channel-4 REC SELECT switch is set to "В,"
the channel 1 through 3 PAN controls must be rotated
full clockwise
(right) to assign the: track 1, 2 and 3
signals to track 4 of the tape. The channel-4 PAN con-
trol can be set to center.:
«AUX RETURN
Control
Set to MIN for the time being.
«MONITOR SELECT Switch
Set to MIX so you'll only hear signals from the MT120S
recorder.
e MONITOR
Controls
Set the channel 1 through
3 MONITOR
controls fully =
counter-clockwise, and the channel-4 MONITOR control
to about center or a position that will provide the best
monitoring level.
18 MT120S MULTITRACK CASSETTE RECORDER
. Play back the tape. Gradually increase the MASTER
fader setting until you can hear the tracks you've recorded
and.the channel-4 meter reads around "0" on the meter
scale. Adjust the MONITOR 4 control for the most com-
fortable monitoring level.
: Adjust the input 1, 2 and 3 faders — carefully — until
you get the desired balance between the first three
tracks. You'll notice that as you adjust the balance
between tracks the channel-4 meter reading might change
considerably. You'll have to compensate for this as you
set up the ping- ES mix T авиаг
the MASTER
дө
"e:
„At this time the GRAPHIC EQUALIZER may be switched
"on" and used to enhance the sound-quality of tracks as
they are combined.
. AUX SEND controls on the channels may be used to
add
an
effect to the balance.
The
amount
of effect
added is controlled by the AUX RETURN fader.
. When everything is set up perfectly, rewind the tape to
`6. Complete your recording by eina
and using the
Ping-Pong technique as necessary.
Qu
La
[Note] Only one output (left or right).of the effect will be
recorded. If the RECORD SELECT switch is set to
"L", the output of the effect processor connected
to the LEFT AUX RETURN jack will be recorded.
If the RECORD
SELECT switch is set to "R", the
output of the effect processor connected to the
RIGHT AUX RETURN jack will be recorded.
Werbung
