Werbung
Verfügbare Sprachen
Verfügbare Sprachen
OVERDUBBING
1. Plug the instrument or other source to be recorded into
an available channel input.
2. Make sure that the REC SELECT
switches of previ-
ously-recorded tracks are set to OFF so that previously
recorded tracks aren't erased when the new track is
recorded.
3. Set up the channel-to-track
assignment for the new
track.
4. Check your monitor settings to ensure that you can
б
monitor the previously recorded track(s) ав well as the
|
new track to be recorded (the MONITOR SELECT switch
should normally be set to MONITOR.)
5. Set the recording level for the new track.
6. You can now "rehearse" the overdub without actually
recording by simply playing back the already-recorded
track(s) and playing the new
part. When
MONITOR
select is in the MONITOR position, it is not possible to
hear input source unless MT120S's transport is in RECORD
or RECORD/PAUSE.
If you are not ready to actually
record your overdub,
and would
like to hear the new
input source along with previously recorded tracks, set
the MONITOR select switch to the MIX position.
[Note] Rehearsing this way is not the same as using the
rehearsal function for punching in and out (see page
23).
|
;
0)
7. Make sure the tape is rewound to the beginning of the
piece and start recording.
These steps are simply repeated to overdub tracks 3 and
4.
16
MT1205 MULTITRACK CASSETTE RECORDER
Werbung
