Mill PA400WIFI3 Bedienungsanleitung Seite 8

6 millnorway.com
Temperature calibration
See figure 4 on separate illustration sheet
It may occur deviation between the temperature registered by the heater and the
actual temperature in the room. This can be caused by several reasons, however, the most
common is that the heater is placed in a fair distance from where you usually reside. When
you set the temperature to for example 22 degrees, it is only natural that you expect the
same temperature where your sofa is placed for instance. However,
the temperature sensor is placed on the product itself, and therefore a deviation in tem-
perature may occur. To adjust this, all Mill heaters are equipped with a calibration function,
which enables you to adjust the temperature registered by the heater. N.B! The room must
A
have achieved a stable temperature before any calibration.
Press and hold
B
served in the room. Confirm with
For models PA500LWIFI3M, GL500LWIFI3M, PA900WIFI3MP, GL900WIFI3MP
please follow the steps below to activate temperature calibration:
Press ○
the display. Press ○to enter calibration mode. The registered room temperature will blink
on the display. Use + or - button to set the actual temperature observed in the room. Con-
firm with ○
Resetting the heater
A
See figure 5 on separate illustration sheet
Turn off the heater ́ s main switch. Turn the heater back on, within 5 seconds press and
hold . After 20 seconds the display will show "Fr", once you see "Fr" release
B
○
heater will reset to factory settings.
For models PA500LWIFI3M, GL500LWIFI3M, PA900WIFI3MP, GL900WIFI3MP
please follow the steps below to reset the heater:
Press to enter menu. Use + and - button to navigate the menu until you see "Hr" in the display.
○
Press to enter reset mode. Press + or - button to choose between "YES" or "NO". Select
○
option by pressing
a few seconds, the whole display is off, before the heater starts normal operation.
Memory function
The heater remembers all the temperature settings and will automatically return to the de-
sired temperature after a power failure. If your heater is connected to WiFi it will automati-
cally reconnect with WiFi (where all temperatures are saved) after a power cut.
"Open Window" function
The heater has an "open window" function that is activated instantly when it registers a
sudden drop in temperature with more than 5 degrees Celsius in 15 minutes. The heater
○ for 5 seconds and use + or – to set the actual temperature ob-
to enter menu and use + and - button to navigate the menu until you see "CAL " in
or wait 10 seconds for automatic confirmation.
. After selecting "YES", the "YES" label blinks twice and heater restarts. For
○
○ or wait 5 seconds for automatic confirmation.
and the
○