Mill PA400WIFI3 Bedienungsanleitung Seite 7

First use
After turning on the heater for the first time or after an extended period without use, the heater
can produce a burnt odor for a short time. This is normal.
Please read all the instructions carefully before use. Save the instruction manual for future use.
It is also normal for the heater to make "sounds" when it warms up or cools down.
Minimum Distances
Description of heater
A
See figure 1 on separate illustration sheet
MILL INVISIBLE
1. On/Off
2. Wall bracket
3. Temperature sensor
4. Heat emission
5. Thermostat
6. Steel front
Assembly
See figure 2 on separate illustration sheet
A. Drill holes in the wall for holes 1 & 2. Then drill holes in the wall for the topmost holes
(holes 3 & 4 by using 6)
B. Insert the wall plugs into the drilled holes and attach the bracket with 4 screws
C. Place the heater on the lower lugs on the bracket, then hang the heater on the upper
lugs (lift the heater slightly to align the heater with for the upper lugs). Screw in the
locking screws on the top of the bracket (clockwise)
Attention! Horizontal placement only
Power indicator
See figure 3 on separate illustration sheet
If the heater uses power (for example, when it heats up), the power indicator is onϟ
B
MILL GLASS
1. On/Off
2. Wall bracket
3. Temperature sensor
4. Heat emission
5. Thermostat
6. Glass front
5