Stiga AB 500 Li 48 Gebrauchsanweisung Seite 27

PROBLEM
7. The battery charger
is not recharging
the battery
8. The LED indicator
(Fig. 5.E) remains
ON in steady mode
9. The LED indicator
(Fig. 5.E) remains ON
in flashing mode
If problems persist after having performed the operations described above, contact your dealer.
14. ACCESSORIES ON REQUEST
14.1 ALTERNATIVE BATTERIES
Different capacity batteries are available to
suit specific operating requirements (Fig. 10).
The list of approved batteries for this machine
is found in the "Technical Data" table.
All manuals and user guides at all-guides.com
PROBABLE CAUSE
Battery is not correctly inserted
in the battery charger
Unsuitable environmental conditions
Dirty contacts
The battery charger is not energised
Faulty battery charger
Self-check failed
Battery communication error
Rotor blocked
Current overload
PCB overheated
Check it is correctly inserted
Recharge the battery in places with
suitable temperatures (see battery/
battery charger instruction manual)
Clean the contacts
Check it is plugged in and the
power socket is energised
Replace with an original spare part
If the problem persists, refer to the battery/
battery charger manual
Do not use the machine. Immediately
turn off the machine,
and contact a service centre.
Do not use the machine. Immediately
turn off the machine,
and contact a service centre.
Do not use the machine. Immediately
turn off the machine,
and contact a service centre.
Optimize machine usage.
Do not use the machine. Immediately
turn off the machine,
and contact a service centre.
14.2 BATTERY CHARGER
Device used to recharge the
(Fig. 11.A), standard (Fig. 11.B).
EN - 15
SOLUTION
(par. 7.2.3)
remove the battery
remove the battery
remove the battery
remove the battery
battery: fast