Stiga AB 500 Li 48 Gebrauchsanweisung Seite 21

E. Battery charger (accessory available
upon request, par. 14.2): device used to
recharge the battery; its specifications
and regulations for use are described in
a specific manual. Two battery charger
models are available: E1 (fast battery
charge); E2 (standard battery charge).
4. ASSEMBLY
IMPORTANT The safety regulations
to follow are described in chap. 2. Strictly
comply with these indications to avoid
serious risks or dangers.
For storage and transport purposes, some
components of the machine are not installed
in the factory and have to be assembled after
unpacking. Follow the instructions below.
Unpacking and completing the
assembly should be done on a flat and
stable surface, with enough space for
machine handling and its packaging,
always making use of suitable equipment.
Do not use the machine until all the
indications provided in the "ASSEMBLY"
section have been carried out.
4.1 ASSEMBLY COMPONENTS
The packaging includes assembly components.
4.1.1 Unpacking
1. Carefully open the packaging, paying
attention not to lose components.
2. Consult the documentation in the
box, including these instructions.
3. Remove all the unassembled
parts from the box.
4. Remove the machine from the box.
5. Dispose of the box and packaging in
compliance with local regulations.
Before assembling, make sure the
battery is not inserted in its housing.
4.1.2 Assembly / disassembly
of the blower tube
1. Align the locking device (Fig.3.A)
with the protrusion (Fig. 3.B) on
the air outlet (Fig. 3.C).
All manuals and user guides at all-guides.com
2. Push the tube (Fig. 3.D) until it hooks
up firmly with the drive unit with a
"click" when it locks in place.
– To remove the tube, press the button
(Fig. 3.A) and then slide it out.
IMPORTANT Stop the machine and
always remove the battery (paragraph 7.2.2)
whenever the blower tube is removed.
5. CONTROLS
5.1 SAFETY BUTTON (ACTIVATION /
DEACTIVATION DEVICE)
Press this button (Fig. 5.A) to activate
and deactivate the machine's
electrical circuit; the corresponding
LED comes "ON" (Fig. 5.C).
Pressing the speed button (Fig.5.D)
sets the air power and the 3
corresponding LEDs come "ON"
(Fig. 5.F). If work is interrupted
(without turning off the machine), on
resumption the machine will start
again at the previously set speed.
LEDs off: The electrical circuit
is completely deactivated.
IMPORTANT Do not keep
your finger on the button when
moving the machine to avoid
accidentally enabling the machine.
The "Warning" icon (Fig. 5.E) comes
ON in the event of machine fault (refer
to the troubleshooting table, par. 13).
5.2 THROTTLE CONTROL LEVER
Operating the throttle control lever
(Fig. 5.F) allows the machine to start /
stop and simultaneously engages /
disengages the cutting means.
For machine start up:
– press the throttle control lever.
The machine stops automatically as the
throttle control lever is released.
EN - 9