Werbung
Verfügbare Sprachen
Verfügbare Sprachen
In general, when used in those concentrations recommended by the manufacturer, either phenolic type or
quaternary type disinfectants can be used. Iodophor type disinfectants are not recommended for use be‐
cause staining may result.
Suggested cleaners for the 6082 MX-PRO R3 cot surface:
S
Quaternary Cleaners (active ingredient - ammonium chloride)
S
Phenolic Cleaners (active ingredient - o-phenylphenol)
S
Chlorinated Bleach Solution (5.25% - less than 1 part bleach to 100 parts water)
Avoid over saturation and ensure the product does not stay wet longer than the chemical manufacturer s
guidelines for proper disinfecting.
WARNING
S
SOME CLEANING PRODUCTS ARE CORROSIVE IN NATURE AND MAY CAUSE DAMAGE TO
THE PRODUCT IF USED IMPROPERLY. If the products described above are used to clean Stryker
patient care equipment, measures must be taken to insure the cots are wiped with a cloth soaked in
clean water and thoroughly dried following cleaning.
S
Failure to properly rinse and dry the cots will leave a corrosive residue on the surface of the cots,
possibly causing premature corrosion of critical components.
NOTE
Failure to follow the above directions when using these types of cleaners may void this product's warranty.
Removal of Iodine Compounds
Use a solution of 1-2 tablespoons Sodium Thiosulfate in a pint of warm water to clean the stained area. Clean
as soon as possible after staining occurs. If stains are not immediately removed, allow solution to soak or
stand on the surface. Rinse surfaces which have been exposed to the solution in clear water before returning
unit to service.
WARNING
Failure to properly clean or dispose of contaminated mattress or cot components will increase the risk of expo‐
sure to blood borne pathogens and may cause injury to the patient or the operator.
All manuals and user guides at all-guides.com
Cleaning
1-35
Werbung
