Ruby Fires 4114 Bedienungsanleitung Seite 4

LIGHTING THE CERAMIC BURNER
There is a latch for the fire-opening on the topside of the ceramic burner.
When the ceramic burner is not lit, this latch is closed (to prevent the bio ethanol from
evaporating). By opening the latch the fire-opening with the ceramic brick becomes visible.
The ceramic burner can be lit using a long lighter or a long matchstick, but only when nothing is
placed on the opening and the Ruby Fires CLIOO is well filled as described in: 'How to fill the
ceramic burner'
Never ignite a hot Never
appliance.
OPENING AND CLOSING THE LATCH
The latch can be opened using the enclosed handles.
MAINTENANCE
When the ceramic burner has been used very often, discolorations on the top can occur. Black
coating near fire opening can dissolve. This is normal and does not harm the quality of the
product. Do not use an abrasive product for cleaning the insert. Clean the surfaces with a moist
piece of cloth or a non-abrasive stainless steel cleanser. Glass screens can be cleaned with
a ceramic cook top cleaner. Changes and/or alterations to the insert, surface or burner are
unacceptable and will cause the warranty to expire. Ruby Fires cannot be held responsible for
possible damages or personal injuries caused by misuse or incompetent use of the insert and
ceramic burner.
VENTILATION OF THE ROOM
When the ceramic burner is used in closed spaces, adequate ventilation has to be provided! In
addition to carbon dioxide (C02) an adequate supply of fresh air (150 cm2 opening) should be
ensured. Insufficient ventilation can cause poisoning by the odourless carbon monoxide. There are
requirements for the supply of fresh air quantity per fire. Take the minimum roomsize into account
(see below).
type burner ± content Measure. heat
(liters) (cm) (m2)
4114 1
4120 + Silo 40x20x8 ca.
5820 2 60x20x8 ca.
8014 + 8013 2 80x20x8 ca.
11814
Attention!! Temperature of glass screens placed in front of the fire can reach 900-1400C and top of
the bio burner even 2000C, when the burner is in use!
leave small children or
pets unattended
Room
consumpt
(m2) (Itr. p. hr.)
min 25 0,30
25 min 25 0,50
3 min 35 0,50
35 min 35 0,55
min 40
0,65
Problem
Existence of soot
Existence of soot
Duration of fire too
Duration of fi re too
Flames too high
Flames too low, not visible
Burner makes a rustling noise
Flames are blue, not visible
Flames remain after
latch has been closed
WARRANTY
The warranty on this product is 2 years. Any changes on the surface or inside of the ceramic
burner, due to the usage of the product, are not included in the warranty of the ceramic burner.
Ruby Fires reserves the right to make any technical alterations in order to improve the product and
its characteristics / safety.
burning time
(hours) Ruby Fires would like to thank you for the purchase of the ceramic burner. If all the instructions are
3 carefully followed, the ceramic burner will burn free of soot and scent.
3
4
3,5 / 4
Possible cause
Wrong fuel
Fire-opening is covered with
decoration material
short Wrong fuel (e.g. gel)
short Burner has not been filled
completely
Wrong fuel or draft
Burner has not been filled
completely
Wrong fuel (e.g. gel) or
overfilled
Fuel is almost finished
the
Solution
Use ONLY Ruby Fires CLIOO
Make sure the fi re-opening is
free of decoration material
Use ONLY Ruby Fires CLIOO
Extinguish the burner. Let it cool
down for at least
30 minutes and then re-fill.
Use ONLY Ruby Fires CLIOO
Prevent draft!
Extinguish the burner. Let it cool
down for at least
30 minutes and then re-fill.
Use ONLY Ruby Fires CLIOO
Extinguish the burner. Let it cool
down for at least
30 minutes and then re-fill.
Open the latch and quickly
close it again to refrain
the oxygen supply
7