Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ENGLISH
the robot moves in a swaying motion, simulating real scrubbing moves. It starts off
cleaning in zig zag motion, then in Edge mode, and finally returns to the charging base
taking the straightest way and memorizing the route. If it runs out of battery before
finishing, it will recharge and the resume cleaning until finished.
Use the App to enter the water-intensity mode and select the desired intensity and select
between low, medium or high.
Warnings:
•
Do not use the mop outdoors.
•
Remove the carpets before operating the robot under this mode.
•
During operation, control the water level on the Wet & dry tank. If it empties, fill it up
again before continuing scrubbing.
•
Take the Wet & dry tank and the mop out before charging the robot.
Note: In order to ensure perfect scrubbing, moisten the mop before starting scrubbing.
6.
Manual mode: Use the direction buttons on the remote control or on the App to take the
robot to the specific points where you want it to clean.
7.
Back home mode: This mode can be activated from the robot, the App or the
remote control at any point of any cleaning cycle. Once it is activated, the robot will
automatically return to the charging base.
8.
Spiral mode: Select this mode for the robot to carry out an intensive cleaning of a
specific spot. It will start cleaning at a specific point and will move outwards in a spiral
motion. Then, it will return to the starting point in a spiral motion, and will return to the
charging base.
9.
Smart Area mode: Once the home's map has been saved, select this mode for the robot
to clean an area in zigzag motion. The robot will clean the selected area and then will
return directly to the charging base. It will only clean the area selected in the map,
therefore it will go to the point and return to the base without vacuuming.
10. Spot mode: Select this mode if you want to clean thoroughly point in the map, making
the most of the robot's maximum power. The robot will clean a 2x2 m zone in zigzag
motion and then will return directly to the charging base when cleaning is completed.
The robot will only clean the area selected on the map, therefore it will go to the point
and return to the base without vacuuming.
11.
Area mode: Select this mode from the App, the robot will clean a 2*2 m in zigzag motion
and will return to the starting point. The robot will not create any map under this mode.
54
Werbung
