Setting The Powder Quantity; Switching The Appliance On And Off; Attaching And Detaching The Grinding; Clearing Obstructions - Beem 3260 ESPRESSO-PERFECT Bedienungsanleitung

Setting the powder quantity

Switching the appliance on and off

• You can interrupt the grinding process any time by pressing the "ON/OFF" switch again.
• Pull the mains plug after each grinding process.
Attaching and detaching the grinding block

Detaching the grinding block

• Pull the mains plug.
• Take all beans out of the beans tank.
• Turn the grinding block to the right to open the bayonet catch.
• Afterwards take the grinding block upwards out of the beans tank.

Attaching the grinding block

• Pull the mains plug.
• Insert the grinding block in the beans tank and place it on the bayonet catch.
• Afterwards turn the grinding block to the left as far as it will go to close the bayonet catch.
NOTE: When attaching and detaching the grinding block, the coarseness setting can change. This can
be avoided by holding the rotary knob of the coarseness tight while loosening or fixing the grinding
14
• Turn the rotary knob to the left (min. 2 cups) or to the right
(max. 12 cups) to the desired position.
• Connect the appliance to the mains. Cord which is not needed can
be stored in the cord storage on the underside of the a ppliance.
• Press the "ON/OFF" switch. The appliance starts the time-
controlled grinding process. After the set time has been reached,
the appliance switches off automatically.