Chef S66MT64001 Bedienungsanleitung Seite 21

5. INSTALLATION
Unloading and handling the hood
The hood must be unloaded and handled via a forklift, pallet truck and/or lifting equipment that is suitable for the weight to be
lifted (see the Technical Data tables).
Positioning and assembling the hood
THE HOOD MUST BE INSTALLED BY QUALIFIED PERSONNEL IN ACCORDANCE WITH THE
!
MAKE SURE THAT THE SUPPORTING SURFACE OF THE OVEN, I.E. THE LOCATION WHERE THE
!
HOOD WILL BE INSTALLED, HAS AN ADEQUATE LOAD-BEARING CAPACITY AND IS LEVEL.
!
REMOVE ANY POLYSTYRENE PROTECTIONS AND THE PROTECTIVE FILM WITHOUT USING
m
OVERHEATING RISK: DO NOT PLACE ANYTHING ABOVE THE HOOD.
m
THE APPLIANCE MAY OVERHEAT IF THE FUME OUTLET HOLE IS OBSTRUCTED.
The hood designed for mechanical ovens is always fitted with a light (position 2) and controls to turn on the light (position 1).
If fitted with an extractor motor, the controls (position 1) can also be used to switch on and adjust the motor.
It must be positioned above the oven and secured with the appropriate screws (see the instructions enclosed in the hood's
packaging).
The hood must be connected to a single-phase socket (10 A, 230 V, 50 Hz).
LOCAL, NATIONAL AND EUROPEAN REGULATIONS.
WARNING!
TOOLS THAT COULD DAMAGE THE SURFACES.
WARNING!
WARNING!
21