SICK RJ45 Bedienungsanleitung Seite 14

MOUNTING INSTRUCTIONS
7.3 Ethernet for PROFINET PROFIsafe, data output, configuration and diagnostics (XF1,
XF2)
en
8 Replacing the safety laser scanner
14 M O U N T I N G I N S T R U C T I O N S | microScan3 – PROFINET (RJ45, SCRJ)
RJ45 female connector, for push-pull male connector (copper)
2
1 3 5
Network pin assignment
Pin Designation Function
1 TX+
2 TX–
3 RX+
4 –
5 –
6 RX–
7 –
8 –
Housing SH
SCRJ female connector, for push-pull male connector (optical fibers)
1
Network pin assignment
Pin Designation Function
1 TX
2 RX
If the safety laser scanner is damaged or defective, you must replace it.
DANGER
Hazard due to lack of effectiveness of the protective device
If an unsuitable configuration is saved in the system plug, it may cause the dangerous
state to not end in time.
After replacement, make sure the same system plug is used or the configuration is
b
restored.
Make sure that the safety laser scanner is aligned correctly after the replacement.
b
4 6 8
7
Send data +
Send data –
Receive data +
Reserved
Reserved
Receive data –
Reserved
Reserved
Shielding
2
Send data
Receive data
8021229/1H7G/2022-10-19 | SICK
Subject to change without notice