EuroLite LED KLS-180 Bedienungsanleitung Seite 29

DMX-CONTROLLED OPERATION
You can control the devices individually via your DMX-controller.
DMX-Mode
The device has four different DMX channel modes. The Control Board allows you, as described below, to
assign the DMX channel mode.
Addressing
The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the device will respond to the controller.
Press the MODE button until the display shows "Addr". Press ENTER to confirm.
Select the desired DMX Channel Mode 3CH/4CH/8CH/21CH and again press ENTER to confirm.
You can now set the desired address via the UP or DOWN buttons. Press ENTER once again to confirm.
Press the MODE button in order to return to the main menu.
Please, be sure that you don't have any overlapping channels in order to control each device correctly and
independently from any other fixture on the DMX-chain.
If several devices are addressed similarly, they will work synchronically.
Controlling:
After having addressed the LED KLS-180 Compact Light Set, you may now start operating it via your lighting
controller.
Note:
After switching on, the device will automatically detect whether DMX 512 data is received or not. If the data
is received, the display will not blink. If there is no data received at the DMX-input, the display will blink.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective,
- the cable or connector is defective or the signal wires are not properly connected with the input connector.
DMX protocol
3-Channel-Mode
Channel:
1
Red
2
Green
3
Blue
Value: Function:
000 - 255 Increasing intensity 0 – 100 %
000 - 255 Increasing intensity 0 – 100 %
000 - 255 Increasing intensity 0 – 100 %
29/36 00105023, Version 1.2