Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Before taking into operation for the first time, the installation has to be approved by an expert!
Mounting on a speaker system
For mobile use, the device may be placed on a speaker system.
1
On the speaker system, first loosen the fixation screws of the legs. Pull out the legs until the cross struts
stand at a 90° angle to the legs. Tighten the fixation screws of the legs.
2
Loosen the fixation screw on the stand sleeve of the device and install the fixture on the tube via the
holder. Tighten the fixation screw.
3
Caution! The load has to be installed in a balanced way. The carrying capacity of the speaker system
must never be exceeded. The speaker system must be set up in a stable way. Make sure all fixation
screws fit tight.
Adjust the desired inclination-angle on the spots via the mounting brackets and tighten the fixation screws.
DMX-512 connection / connection between fixtures
The wires must not come into contact with each other, otherwise
Please note, the starting address depends upon which controller is being used.
Only use a stereo shielded cable and 3-pin XLR-plugs and connectors in order to connect the controller with
the fixture or one fixture with another.
Occupation of the XLR-connection:
If you are using controllers with this occupation, you can connect the DMX-output of the controller directly
with the DMX-input of the first fixture in the DMX-chain. If you wish to connect DMX-controllers with other
XLR-outputs, you need to use adapter-cables.
Building a serial DMX-chain:
Connect the DMX-output of the first fixture in the DMX-chain with the DMX-input of the next fixture. Always
connect one output with the input of the next fixture until all fixtures are connected.
Caution: At the last fixture, the DMX-cable has to be terminated with a terminator. Solder a 120
between Signal (–) and Signal (+) into a 3-pin XLR-plug and plug it in the DMX-output of the last fixture.
Wireless DMX transmission with QuickDMX
The device features an alternative DMX input for a QuickDMX receiver (sold separately). This connector
allows for wireless transmission of DMX control signals to the device. The connector is designed as a 5-pin
XLR mounting plug which provides the required 5 V operating voltage for the receiver. With QuickDMX
devices, extensive cabling between the DMX controller and the device is not required.
DANGER TO LIFE!
the fixtures will not work at all, or will not work properly.
26/36
Ω
resistor
00105023, Version 1.2
Werbung
