Silvercrest SHM 300 C1 Abbildungen Zur Bedienungsanleitung Seite 9

Food processing attachments
1) Select the desired attachment:
–
the slicer attachment
–
or the grater attachment
2) If a different disk is still installed: Ideally, turn
the disc adapter
long metal tab of the disc inwards with your
thumb so that this side of the disc is released
from the disc adapter
the disc.
3) Insert the new disc with the short metal tab first
into the disc adapter
4) Then carefully push the side with the long metal
tab into the disc adapter
do this is to press with both thumbs on the
outer edges of the attachment until it clicks
completely into place in the disc adapter
5) Place the disc adapter
fitted onto the drive shaft
of the drive shaft
take up of the disc adapter
disc adapter cannot be properly attached.
■ 6 │ GB │ IE │ NI │ CY
.
upside down. Press the
. You can now remove
:
. The best way to
with the attachment
. The flattened side
must correctly fit into the
. Otherwise the
6) Place the lid
arrow ▼ on the lid
arrow and the opened lock symbol
on the bowl
7) Turn the lid
points to the arrow
symbol on the bowl
8) Place the pusher
9) Insert the plug into a mains power socket.
Operation
Using the cutting blades
The cutting blades
such as onions or meat.
NOTE
► Do not attempt to mix liquids with the cutting
blades . These will overflow or spray out.
1) Fit the cutting blades
chapter "Assembling the appliance".
2) Cut the ingredients into pieces of
approximately 2 – 3 cm.
3) Pour the ingredients in. Do not exceed the
quantities specified in the following table.
.
INGREDIENT
Bread
Cheese
Meat
Herbs
Garlic
Onions
Ice cubes
onto the bowl so that the
coincides with the
.
until the arrow ▼ on the lid
and the closed lock
.
into the feed tube
can be used to chop foods
as described in the
MAX. AMOUNT
max. 80 g
max. 150 g
max. 300 g
max. 30 g
80 – 200 g
max. 300 g
max. 140 g
KM 250 C1
.
SPEED
ON
ON
ON
ON
PULSE
PULSE
PULSE