Beurer UB64 Gebrauchsanweisung Seite 12

3. Proper Use
CAUTION
This heated underblanket is designed for warming beds, only.
4. Operation
4.1 Safety
CAUTION
This heated underblanket is equipped with a SAFETY SYSTEM. This sensor technology prevents the
entire surface of the heated underblanket from overheating by automatically switching off the heated
underblanket in the event of a fault.
If the safety system has switched off the heated underblanket, the temperature setting is not illuminated
any more even when the heated underblanket is switched on.
Please note that the heated underblanket is not operable any more due to safety reasons in this case
and has to be sent to the service address indicated.
4.2 Putting into operation
Spread out the heated underblanket flat on your mattress so that the cable entry is located at approximately
shoulder height (see illustration). The head section is not heated.
Then pull the side section over the sides of your mattress like a fitted sheet. The heated underblanket is
designed to fit mattresses in sizes 35x80 in (90x200 cm) and 38x80 in (100x200 cm).
Then secure your fitted sheet as usual so that the heated underblanket is between your mattress and the
fitted sheet.
CAUTION
Make sure that the heated underblanket is spread out entirely flat and that it will not rumple up or
crease when in use.
• To operate the heated underblanket connect the controller to the heated underblanket by plugging in the
connector.
• Then plug in the supply plug into the mains outlet.
4.3 Switching on
To switch on the heated underblanket, set the slider for ON/OFF and temperature settings to setting 1, 2 or 3.
When it is switched on, the indicator lamp (4) lights up.
4.4 Setting the temperature
Setting 0: OFF
Setting 1: minimum heat
Setting 2: medium heat
Setting 3: maximum heat
WARNING
If the heated underblanket is used continuously (for several hours) it is
recommended to use the lowest setting of the control to avoid overheat-
ing of the user.
12