Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Using the timer function
When activating the timer for several cooking zones
• If the timer is activated for several cooking zones,
the timer display always shows the lowest remaining time.
A flashing red dot under the corresponding power display
indicates the cooking zone to which the display refers
(Example see illustration).
To display the remaining time of the timer
of another cooking zone,
touch the corresponding selection key.
• After the shortest set time has elapsed,
the corresponding cooking zone switches off,
the display changes to the next lowest remaining time
and the dot of the corresponding zone flashes.
• When the last remaining time set expires finally,
this cooking zone is also switched off.
4.2 Alarm setting without switch-off
After activating this timer function, an alarm signal
sounds when the set time has elapsed.
Cooking zones that had been switched on
remain in operation.
• To activate the alarm function, touch the timer key
without having selected a cooking zone first.
The timer display starts flashing and shows "30" (30 min).
• To set the time for the alarm,
proceed as for setting the timer for the auto switch-off.
• After the set time has elapsed, a beep sounds.
However, cooking zones that are switched on remain
in operation.
• To stop the alarm, touch the timer key again several times
until the timer display shows "--".
68
Setting:
5 min.
Setting:
15 min.
Remaining
time:
0 min.
Remaining
time:
10 min.
Werbung
