Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Using the hob
3.4 The flex zone function
• The front and rear cooking zones left and right (cooking zones
1 and 2, or 3 and 4) each form a flex zone.
Each Flex Zone consists of two independent induction zones
that can be connected together as one large zone.
• If, during operation as one large zone, the cookware is moved
from the front part to the rear part (or vice versa) within the flexi-
ble area, the new position is automatically detected;
the power level of the zone on which the cookware was originally
placed is maintained and the part not covered by the cookware
is automatically switched off.
• Important note: In flex-zone operation, the cookware must be
placed in the middle of the zone, so that both cooking zones
are evenly covered.
Examples of good and bad placement of cookware:
Using as one large zone
• To operate the flex zone as one large zone,
press the corresponding flex zone key.
• The power level is set as with the other cooking zones
using the slider.
Use as two smaller independent zones
• To operate the flex zone as two independent single zones,
press the corresponding flex zone key again.
66
≥ 200 mm
Werbung
