Werbung
Verfügbare Sprachen
Verfügbare Sprachen
UPPER LED
Green
Red
Blue
Yellow
Flashing green
White
Flashing red
Flashing yellow
LOWER LED
Red
The appliance heating element is on.
Off
The heating element is off.
Blinking red (2
Transmission of the signal from the
seconds)
Control Panel
Blue
An open window has been detected.
Malfunctioning
The Command is equipped with a beeper that signals the
beeps (see Section 4.3).
4.2.2 INFRARED CONTROL PANEL
The Control Panel communicates with the Command via in-
frared rays.
For good communication do not cover either the Control
Panel or the Command and do not obstruct the infrared
transmitter or receiver in any way (see Fig. 10).
Standby
Pilot Wire
Comfort
Anti-Freeze
Chrono
Overdrive (2h)
Discharged batteries
Malfunctioning
Fig. 10
Infrared
transmitter
The Command responds to the settings received from the
Do not spray water or other liquids into the Control Panel.
Power supply: "AAA" LR03 1.5 V alkaline batteries
Inserting or replacing the batteries:
– Remove the cover on the front of the Control Panel (see
Fig. 11).
Fig. 11
– Insert two "AAA" LR03 1.5 V alkaline batteries. When insert-
ing the batteries, always respect the polarity (+ and -) indi-
cated on the battery and the appliance.
– Put the cover back.
always use batteries of the same type and brand.
Flat batteries must be removed from the appliance
immediately and disposed of appropriately. When
replacing the batteries or disposing of the remote
control, the batteries must be removed and dis-
posed of in compliance with current legislation as
they are harmful to the environment. Never throw
Keep batteries away from children.
19
Infrared receiver
-
GB
Werbung
