DeLonghi AQVA Bedienungsanleitung Seite 26

Fig. 12
GB
SUGGESTED AREA
The appliance's reaction to windows opening and clos-
ing depends on many factors, such as the temperature
set on the appliance, external temperature, the degree
of ventilation inside the room, the towel warmer's po-
sition and the presence of other heating sources.
The "Open Window" function cannot be activated
or deactivated in "Standby" mode.
If the appliance detects an open window, all the
operating modes and the "Overdrive (2h)" function
can be selected, however will not be active until
detected as the window is closed. The "Children
Safety" and "Keypad Lock" functions remain active
and can be activated and deactivated even when
the appliance has detected an open window.
4.5.3 OVERDRIVE (2h)
The "Overdrive (2h)" can be used to heat the room quickly.
To activate the function, press the "Mode" key
until the
The minutes left until the end of the two hours are displayed
in place of the time. The upper LED on the appliance turns
The appliance heats at the maximum power for 2 hours, inde-
pendently from the temperature setting. To deactivate "Over-
drive (2h)" function at any time, press the "Mode" key again.
After 2 hours since activation, the "Overdrive (2h)" exits uto-
matically and the appliance returns into the previously se-
lected operating mode.
The "Children Safety" function limits the heating
power of the appliance even when the function
"Overdrive (2h)" is active.
If the appliance detects an open window, the
"Overdrive (2h)" function will not be active until
the window is detected as closed, or the "Window
Open" function is deactivated (see Section 4.5.2)
while the countdown continues to the end of the
two hours.
∞
symbol is displayed.
4.5.4 CHILDREN SAFETY
When the "Children Safety" function is activated, the surface tem-
perature of the appliance is lower than in normal operation in the
caused by brief accidental contact.
To activate the function, press the "+" and "-" keys
together and hold them both down until the icon
≈
appears on the display.
To deactivate the function, repeat the same operation.
"Children Safety" can be activated in all operating modes,
including "Overdrive (2h)". The function cannot be activated
when the appliance is in "Standby".
IMPORTANT:
When this function is active, the appliance heats at reduced
power and therefore the room takes longer to warm up.
Even when this function active, children should still
be supervised to make sure they are not in danger.
Always avoid prolonged contact between the ap-
pliance and the body.
If the appliance is already operating or is still hot after
recent use and "Children Safety" is activated, it takes
at least two hours for the temperature to drop to the
lower value and the function to be operational.
4.5.5 KEYPAD LOCK
It is possible to lock the Control Panel keypad to prevent ac-
To activate the function, press the "Mode"
and "+" keys together and hold them both
down until the icon
To unlock the keypad, press the same two keys together as
before.
The "Keypad Lock" icon will no longer appear on the LCD.
IMPORTANT:
The "Keypad Lock" function does not inhibit the
"Standby" key. This is therefore always active, even
when the "Keypad Lock" function is enabled.
24
◊
appears on the display.