Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Starting up the device
Once the wine cabinet is properly installed, we advise that you clean the inside using warm water with a
low concentration of dish washing liquid. Do not use abrasives or scouring powder; they may scratch the
surface finish.
USAGE
CAUTION! Wine cabinets are intended only for storing and preserving wine.
IMPORTANT: Your wine cabinet is ideally suitable for holding Bordeaux type bottles of 0.75 L capacity. It
can contain larger bottles; however care must be taken that they do not prevent the door from closing
properly.
When closing the door ensure that it does not touch any of the bottles.
-
If you load several bottles at a time, it will take longer before the cabinet reaches the desired
-
temperature.
-
In order to avoid damaging the door seal, ensure that the door is fully open before moving the
racks along the compartment rails.
Adjusting the temperature
Control panel
1. Light button
2. Compressor operation indicator
3. Temperature unit change
4. Upper zone temperature
5. Lower zone temperature
6. Temperature unit
To switch the wine cellar on or off, press buttons 7 and 9 simultaneously.
To change the temperature unit, press button 3 for a few seconds. The corresponding light 6 will indicate
the selected temperature unit (°C or °F).
To switch the interior light on or off, press button 1
The light (LED) is suitable for storing wine. However, it is advisable to turn the light off during normal use.
It is possible to adjust the temperature degree by degree; the temperature is set with the
located to the right of the temperature indicator.
Each press of the
degree.
To obtain a lower temperature than that indicated, press repeatedly until the display shows the desired
temperature.
1
2
3
4
increments by one degree. Similarly, each press of the
USAGE
5
6
7. Knob to adjust the temperature of the upper
zone
8. Resistor operation indicator
9. knob to adjust the temperature of the lower
zone
7
8
9
or
Decreases by one
EN-28
Werbung
