Cameo Q-SPOT 40i Bedienungsanleitung Seite 6

OLED DISPLAY
5
The OLED display shows the currently active operating mode (main display), the menu options in the Options menu, and the numerical
values or operating status for certain menu options. If there is no input within approx. 30 seconds, the display automatically switches to the
main display. If one of the four DMX operating modes is activated and there is no DMX control signal on the DMX input, then the numbers on
the display will flash; this flashing stops once a control signal is received.
TOUCH-SENSITIVE CONTROLS
6
MODE
Access the selection menu by pressing MODE. Pressing it again will return you to the main screen. If you press the MODE button without
having first pressed ENTER to confirm a value or status change, the previously confirmed value or status shall be restored.
ENTER
Pressing ENTER will take you to the menu level in order to apply value changes and to reach one of the submenus. You can also confirm
value adjustments by pressing ENTER.
UP and DOWN
Selects the individual menu options in the selection menu (DMX address, operating mode, etc.) and in the submenus. Allows you to change
the value of a menu option, such as the DMX address, as desired (press down and hold for rapid value adjustment).
PRESSURE EQUALIZATION ELEMENT
7
The pressure equalization element, for preventing the buildup of moisture inside the housing, is on the side of the housing. Protect this
element from contamination in order to ensure that it functions properly.
ADJUST BEAM DIRECTION
8
A 6 mm hex tool is required to adjust the stand or mounting bracket (not included in delivery).
SAFETY EYEBOLT
9
When installing in an overhead location, secure the device using a suitable safety cable on the safety eyebolt.
IMPORTANT NOTE: Always carefully connect the cable and sealing caps to the cable connectors to ensure a waterproof connection in
accordance with IP65.
OPERATION
NOTES
• As soon as the spotlight is correctly connected to the power mains, "Software Update Please Wait..." (only for servicing purposes), "Wel-
come to Cameo", the model name, and then the software version are displayed in sequence on the display as part of the startup process.
Once the process is complete, the spotlight is ready for use and resumes whichever mode was most recently set.
• If one of the DMX modes is active, and there is no DMX signal at the DMX input, the display will begin to blink after a few seconds.
• After approx. 30 seconds of inactivity, the display will automatically show the currently active operating mode (main display).
• Fast Access feature: In order to make navigating the menu simpler, the device has an intelligent menu structure that makes it possible
to directly access menu and submenu options that were previously selected. 1. Pressing MODE and ENTER at the same time will take you
directly to the submenu option that was last modified, where you can immediately change the value as desired (DMX start address and all
operating modes). 2. Pressing MODE will take you directly to the menu option that was last selected and modified.
• Before changing device settings, make sure that the control unit is dry and dust-free in order to ensure that it is functioning properly.
• The display can be rotated by 180° by pressing UP when the main screen is shown on the display.
SETTING THE DMX START ADDRESS
Press MODE until the top line of the display shows "Menu". Now select the "DMX Address" option (bottom line) using UP and DOWN (note
arrow) and then press ENTER. Now select the desired DMX start address using UP and DOWN and confirm with ENTER (the highest value
depends on the selected DMX mode). The last selected DMX mode will activate at the same time.
6