Cameo Q-SPOT 40i Bedienungsanleitung Seite 8

SYSTEM SETTINGS (Settings)
Press MODE until the top line of the display shows "Menu". Now select the "Settings" option (bottom line) using UP and DOWN and press
ENTER. You can now select the desired submenu item using UP and DOWN and confirm with ENTER (see table, status / change value with UP
and DOWN, confirm with ENTER):
Settings (bold = factory setting)
Display Rev = Display rotates by 180°
Display = Automatic display deactivation
DMX Fail = Operating status if DMX signal
is lost
Dim.Curve = Dimmer curve
Dimmer = Dimmer response
Resp.
Autolock = Automatically locks the control
elements
White = White balance
Balance
IR Remote = Activate or deactivate control via
the IR remote
Factory = Reset to factory settings
Reset
8
Display Rev On Rotate display by 180°
(e.g. for overhead installation)
Display Rev Off Normal display rotation
Display On Permanently on
Display Off Automatic deactivation of the display after approx. 1
minute of inactivity
Hold
Last command is kept
Blackout Activates blackout
Linear Light intensity increases linearly with DMX value
Exp Light intensity can be finely adjusted at lower DMX
values and broadly adjusted at higher DMX values
Log Light intensity can be broadly adjusted at lower DMX
values and finely adjusted at higher DMX values
S-curve Light intensity can be finely adjusted at lower and
higher DMX values and broadly adjusted at medium
DMX values
LED The spotlight responds abruptly to changes in the
DMX value
Halogen The spotlight behaves like
a halogen spotlight with soft brightness changes
On Automatically locks the control elements after approx.
1 minute of inactivity Display shows: "Locked!"
Unlock: Press UP and DOWN at the same time for
approx. 5 seconds
Off Deactivates automatic locking of the control elements
Red, green, blue, Individual white balance. Cross-mode configuration of
amber the 4 colors RGBA (value 000–255)
On Activate control via the IR remote
Off Deactivate control via the IR remote
Reset Now? ENTER = reset to factory settings
MODE = do not reset to factory settings