ABB ACS310 Montageanleitung Seite 2

6b
6. Install the clamp (6a) for the control cable, or if cables are run
in conduits, replace all clamps with suitable glands (not
included). Run cables through the clamps and tighten. Strip
cable ends. Fasten the grounding conductor (PE) of the input
power cable and the twisted shield of motor cable under the
grounding clamps (6b). Connect the conductors to appropriate
terminals. See Electrical installation in the drive manual.
10
10. Fasten the hood to drive with two M3×12 screws.
11. Fasten the hood to wall with one M4 screw (not included).
ABB Oy Drives P.O. Box 184 FIN-00381 HELSINKI FINLAND Tel. +358 10 22 11, Fax: +358 10 22 22681, Internet: http://www.abb.com
6a
7. Install the gland box cover.
8. Fasten the cover with two M4×12 screws.
11 11
12. Drive with MUL1-R3 option installed.
9
7
8
9. Install the hood. First position the front edge carefully, then
press the hood downwards until it snaps on.