Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Note
• By the demand input, it is possible to save on power costs by reducing the power
consumption.
• When demand input is released, you can set whether or not to conform operation of the unit
to nearest schedule before release time of the day.
• In case schedule of the day is not set, it will be the operation mode, set temperature and
remote controller permission/prohibition setting which is just before the demand input.
• Up to three demand levels can be set. In level 1, the set temperature of the air conditioner
set to D1 shifts by 2 deg C (+2 deg C in cooling or dry mode or -2 deg C in heating mode). In
level 2, the units set to D1 or D2 switch to fan mode. In level 3, the units set to D1, D2, or D3
switch to fan mode.
* To use the demand control, a demand signal must be inputted. For more information,
contact your installation contractor or dealer.
13.
Press the Energy saving cell.
•
VALID: The unit is set for energy saving.
■ Setting Icon for the group
14.
Press the ICON button, and select an icon. Press the OK button. When changing the
page, press the
Note
Icons can be decided by model of units, when you press AUTO CONFIG button on GROUP
DEFINITON screen.
■ Setting Unit type for the group
15.
Select Air-Conditioner or Other. When you select "Other", you can't set mode,
temperature setting, fan and air direction.
■ Setting FAN TYPE for the group
16.
Choose a type from 1-speed, 2-speed(Hi-Me), 2-speed(Hi-Lo), 3-speed and 4-speed by
pressing FAN TYPE button.
■ Setting and unsetting louver for the group
17.
Press the VALID or INVALID button.
•
VALID : group which can be set air position
•
INVALID : group which cannot be set air position
■ Setting and unsetting "ALL" command for the group
18.
Press the VALID or INVALID button.
•
VALID: group set up for batch operation
•
INVALID: group not set up for batch operation
or
button.
– 35 –
page 71
Werbung
