Atlantic F620 Bedienungsanleitung Seite 39

The appliance can save a maximum temperature (of between 19°C and 28°C), which the
settings cannot exceed. By default, it is set to 28°C.
1- Press and hold the
display .
2 - Press to display
3 - Press , will flash alternately with the currently set maximum temperature
4 - Set the new value using the
5 - Press to exit.
Example: I want to prevent a temperature above 24°C from being set.
> 3 s
HEATING STANDBY INDICATOR
There is an automatic timeout on the control panel display after a few seconds, with the
exception of the heating indicator, which is lit when the resistor is powered on. It is
possible to configure the panel so that the indicator goes out when the panel display is
switched off.
1 - Press and hold the
display .
2 - Press twice to display
3 - Press , will flash alternately with
4 - Press to display
5 - Press to exit.
> 3 s
X2
It is possible to reset the appliance, erasing all the settings made (programs, calibration,
maximum temperature, heating indicator). This function is particularly useful in case of
programming errors.
1 - Press and hold the
display .
2 - Press 3 times to display
3 - Press , will flash alternately with
4 - Press to display
5 - Press to confirm. All the indicators will light up. The appliance will then return to
Comfort mode at 19°C.
> 3 s
X3
MAXIMUM TEMPERATURE
and buttons at the same time for more than 3 seconds to
(Max. Temperature).
buttons (between 19°C and 28°C).
X4
and buttons at the same time for more than 3 seconds to
(Heating Indicator).
.
FACTORY SETTINGS
and buttons at the same time for more than 3 seconds to
(Factory Settings).
.
38
18
.
.
EN
.