Werbung
Verfügbare Sprachen
Verfügbare Sprachen
OPERATING INSTRUCTIONS
Troubleshooting
7.
Troubleshooting
Problem
The radiator does not switch on.
The radiator does not heat up.
The radiator stays hot.
The radiator does not heat up
enough.
The radiator heats in Eco mode.
The radiator's surface is very hot. It is normal for the surface to be hot when working. The maximum values comply with the limits
The temperature in the room dif-
fers from the temperature set.
The radiator gives off an unpleas-
ant odour.
8.
Maintenance
- This product does not require any special maintenance.
- Clean the product, especially the heating panel, with a dry cloth once every 6 months.
- If the product requires repairing, contact an authorised technical service centre.
- When replacing the power cable, use a 2x1,00mm
for cables both with and without plugs, must be performed by qualified personnel and never by the end user in order to avoid
damaging the appliance and jeopardising personal safety.
9.
Legal notice
Environment and recycling
Please help us to protect the environment by disposing of the packaging in accordance with the national regulations
for waste processing.
Recycling of obsolete appliances
Appliances with this label must not be disposed off with the general waste. They must be ollected separately and dis-
posed off according to local regulations.
32
Solution
Check that the power supply is on and that it is as indicated in the radiator's nameplate (e.g. 230
Vac 50 Hz), and that the main switch on the right side of the radiator is switched on (position „I").
Make sure that the operating mode is as required and, if using a preset programme, that you
are not in a time period for which anti-freeze mode is set.
If the ambient temperature is higher than that set, the radiator should not heat up.
If in doubt, set Comfort mode and a required temperature much higher than the ambient tem-
perature, to check that the radiator is working properly.
Check that the temperature setting is not too high or that there are no draughts on the radiator,
altering the ambient temperature measured.
Check that the temperature setting is not too low, that the radiator is only heating the room in
which it is installed (keep the doors closed) and that the mains power supply is correct.
The radiator may heat up to reach / maintain the eco temperature. This is not abnormal operation.
laid down by applicable safety norms.
If the radiator is always very hot, it may be undersized for the space in which it is used, or may
be affected by draughts.
Having waiter for the ambient temperature to stabilise for at least 4 hours, you may have to
compensate for any differences between the temperature indicated by the radiator and that
measured in the room. To do this see the contents of paragraph 6.3 on the section „Aligning the
outside temperature".
When the radiator is new, it is possible that when it begins working for the first time an unpleasant
odour may be sensed. This is due to residue from the manufacturing process.
Radiators that have already been used may give off unpleasant odours if they are not used for a
long time and/or if they are used in polluted spaces with poor quality air.
2
or 3x1,00mm
2
H05V2V2-F HAR type, depending on the version. This operation,
Werbung
