Scheppach HD2P Original Bedienungsanleitung Seite 20

Notes on the use of borehole-suction nozzle
(fig. 8)
• Attach the drill suction nozzle (9) to the suction
hose.
• Switch on the suction device and place the drill suc-
tion nozzle onto the borehole.
• Due to the vacuum, the nozzle sticks to level sur-
faces.
Use of the inflation nozzle (fig. 9 - 10)
• The suction-blowing nozzle (7) can be used for suc-
tion or inflating of suitable objects. Set the suction
device to blowing mode.
• Place the suction-blowing nozzle onto the suction
hose.
• Switch the suction device on.
• By covering the borehole (a) on the nozzle, you can
regulate the airflow
9. Electrical connection
The electrical motor installed is connected and
ready for operation. The connection complies with
the applicable VDE and DIN provisions.
The customer's mains connection as well as the
extension cable used must also comply with these
regulations.
Damaged electrical connection cable
The insulation on electrical connection cables is of-
ten damaged.
This may have the following causes:
• Passage points, where connection cables are
passed through windows or doors.
• Kinks where the connection cable has been improp-
erly fastened or routed.
• Places where the connection cables have been cut
due to being driven over.
• Insulation damage due to being ripped out of the
wall outlet.
• Cracks due to the insulation ageing.
Such damaged electrical connection cables must not
be used and are life-threatening due to the insulation
damage.
Check the electrical connection cables for damage
regularly. Make sure that the connection cable does
not hang on the power network during the inspection.
Electrical connection cables must comply with the ap-
plicable VDE and DIN provisions. Only use connection
cables with the marking "H05VV-F".
20 | GB
The printing of the type designation on the connection
cable is mandatory.
AC motor
• The mains voltage must be 230 V~
• Extension cables up to 25 m long must have a
cross-section of 1.5 mm
Connections and repairs of electrical equipment may
only be carried out by an electrician.
Please provide the following information in the event
of any enquiries:
• Type of current for the motor
• Machine data - type plate
• Motor data - type plate
If you return a motor, always send back the entire drive
unit with switch.
Connection type Y
If the mains connection cable of this device is dam-
aged, it must be replaced by the manufacturer, their
service department or a similarly qualified person to
avoid dangers.
10. Cleaning and transport
Warning!
Always pull the mains plug out of the mains socket be-
fore carrying out any work on the electric tool itself (e.g.
transport, installation, conversion, cleaning and main-
tenance work)!
• Keep the suction device and the air vents clean.
• Prior to starting your work, check the filling level of
the dust bag.
• Clean the suction device with a brush or moist cloth.
• Do not use cleaning agents.
11. Storage
Store the device and its accessories in a dark, dry and
frostproof place that is inaccessible to children. The
optimum storage temperature is between 5 and 30˚C.
Store the electrical tool in its original packaging.
Cover the electrical tool in order to protect it from dust
and moisture.
Store the operating manual with the electrical tool.
www.scheppach.com
.
2