Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Electrical connection:
Connecting cables
Volume Control
S1,
Tone Selector Switch
Operation voltage for sounder
**:
Combined beacon-sounders (PY X-MA-xx) can be operated commonly or separately. Adjust S2 and S3 as shown in the table.
Option –SSM (Soft-Start-Module) (24V DC only):
- Limiting of the switch-on current peak to:
PY X-M(A)-05 -SSM:
PY X-M(A)-10 -SSM:
- Connection of the operating voltage to the equipment starts at >7V
- Resistance for the line monitoring mounted.
Operating voltage range: 18V – 30V DC
Connection of a resistor for line monitoring: (dc versions only)
Only in case of separate operation of beacon and sounder:
Flash Frequency adjustment:
S1:
(Beacon)
*
Factory setting
The beacons satisfy the requirements of the standard EN54-23 (Synchronization)
Caution: In order to ensure synchronization, the devices must be operated with the same potential.
085 501 987g
(PCB in base part)
DC versions only
AC versions only
PY X-MA-xx
Operation voltage for beacon
: max. 2,1 A
: max. 2,1 A
Resistor for Line Monitoring (1K Ohm) at the
terminal for operating voltage.
Position of the resistor with parallel connec-
tion of multiple beacons in the last unit
Remove unneeded resistors.
PY X-MA-xx
Connection for
operation voltage
PY X-M-xx
:
max. 2,1 A
:
max. 4,5 A
PY X-MA-xx
within the operating voltage range of 18V - 60V DC
7
PY X-M-xx
PCB
in lens
30360-004-4g
.
Werbung
