Maintenance; Troubleshooting - WOLFF BS 125 Originalbetriebsanleitung

8. Use
Always guide the machine with both hands
on the handles of the angle grinder provided.
7.1 Working close to walls
See illustration C on page 2.
To open and close the segment (15) switch
off the machine and pull the mains plug. The
accessory must be stationary.
Only open the segment (15) by twisting when
working close to walls. For all other work, the
segment must be lowered.
The open area of the safety guard must face the
direction of the wall
8.2 Switching On and Off
Always guide the machine with both hands.
Switch on first, then guide the accessory
towards the workpiece.
Avoid inadvertent starts: always switch the
tool off when the plug is removed from
the mains socket or if there has been a
power cut.
In continuous operation, the machine
continues running if it is forced out of your
hands.
Therefore, always hold the machine with both
hands using the handles provided, stand securely
and concentrate.
Avoid the machine swirling up or taking in
dust and chips. After switching off the
machine, only place it down when the motor
has come to a standstill.
Machines with slide switch:
11
Switching on: Push the sliding switch forward.
(7) For continuous activation, now tilt downwards
until it engages.
Switching off: Press the rear end of the slide
switch (7) and release it.
9.

Maintenance

It is possible that particles deposit inside the power
tool during operation. This impairs the cooling of
the power tool. Conductive build-up can impair the
protective insulation of the power tool and cause
electrical hazards.
The power tool should be cleaned regularly, often
and thoroughly through all front and rear air vents
using a vacuum cleaner or by blowing in dry air.
Prior to this operation, separate the power tool
from the power source and wear protective glasses
and dust mask.
Prior to each use, check if there are parts
missing, worn, broken, torn or damaged.
Do not use defective or incomplete guard.
Replace brush rim (16): replace worn brush rim
for optimum extraction.
See page 2, illustration D.
Pull out worn brush rim and fully insert new brush
tim (#080753).
10.

Troubleshooting

The electronic signal display lights up
and the load speed decreases. (7)
There is too much load on the machine! Run
the machine in idling until the electronics
signal indicator switches off.
The machine does not start. The electronic
signal display (7) (depends on model)
flashes.
The restart protection is active. If the mains plug is
inserted with the machine switched on, or if the
power supply is restored following an interruption
the machine does not start up.
Switch the machine off and on again.
11. Accessoires
Use only genuine accessories.
Use only accessories which fulfil the requirements
and specifications listed in these operating
instructions.
Bar side handle
For a complete range of accessories, see
www.wolff-tools.com or the catalogue.
- 17 -