Victron energy MPPT 100/15 Anleitung Seite 5

2 Safety instructions
Danger of explosion from sparking
Danger of electric shock
● It is advised to read this manual carefully before the product is installed and put into
use.
● This product is designed and tested in accordance with international standards. The
equipment should be used for the designated application only.
● Install the product in a heatproof environment. Ensure therefore that there are no
chemicals, plastic parts, curtains or other textiles, etc. in the immediate vicinity of
the equipment.
● Ensure that the equipment is used under the correct operating conditions. Never
operate it in a wet environment.
● Never use the product at sites where gas or dust explosions could occur.
● Ensure that there is always sufficient free space around the product for ventilation.
● Refer to the specifications provided by the manufacturer of the battery to ensure
that the battery is suitable for use with this product. The battery manufacturer's
safety instructions should always be observed.
● Protect the solar modules from direct light during installation, e.g. cover them.
● Never touch uninsulated cable ends.
● Use only insulated tools.
● Connections must always be made in the sequence described in section 3.5.
● The installer of the product must provide a means for cable strain relief to prevent
the transmission of stress to the connections.
● In addition to this manual, the system operation or service manual must include a
battery maintance manual applicable to the type of batteries used.
3