Karella CB-50 Bedienungsanleitung Seite 20

Assembly instruction
Hang the dartboard in a location where there is a minimum throwing distance of 3 meters. When throwing, stand
behind an imaginary line that is 2.37 meters away from the front surface of the board. The center of the board
(Bull's Eye) should be at a height of 1.73 meters from the ground (official tournament height).
To mount the board at the correct height, mark a point on the wall at 203 cm above the floor. Then, mark a sec-
ond point at the same height with a distance of 40.6 cm from the first marked point. These two marks should
now be where you attach the screws. Please consider the specific conditions of your wall where the board will
be mounted. Ensure that the screws are screwed in as straight as possible so that the dartboard hangs straight
later.
Hang the dartboard by aligning the holes on the back of the dartboard with the screws. The screws may need to
be tightened until the board is securely against the wall.
Oche Line
Power Connection
The Electronic Soft Dartboard CB-50 is powered by a 5V DC, 1.0 A adapter. Insert the adapter plug into the
socket on the right side of the dartboard and plug the power plug into the electrical outlet. Ensure that the voltage
matches that of your household power supply.
Display Protective Film
The display of your electronic dartboard is protected by a transparent film to prevent scratching during trans-
port. We recommend removing this film before your first game to ensure better visibility of the display area. To
remove it, lift the film from one corner, peel it off, and dispose of it.
8072.03 Karella Dartautomat CB-50
20