Turning The Appliance On And Off With The Remote Control; Setting The Desired Temperature Using The Remote Control; Using The Child Safety Lock; Calibrating The Room Temperature Measurement - Fuave Reykjavik 700 Bedienungsanleitung

4.7.4. Turning the appliance on and off with the remote control

ATTENTION!
The appliance will remain in standby mode when turned off using the remote control. To turn the
appliance off completely, see 'Turning the appliance on and off'.
To turn the appliance on and off with the remote control:
1. To turn the appliance on, press the power button for one second. The ROOM indicator is on and the
temperature indication shows room temperature. If the desired set temperature is higher than the room
temperature, the appliance will start heating.
2. To turn the appliance off, press the power button for one second. The screen displays OFF. The appliance
stops heating and is in standby mode.
ATTENTION!
Frost protection remains active in standby mode.

4.7.5. Setting the desired temperature using the remote control

The desired temperature can be set between 5°C and 30°C. When the infrared panel heats, the screen shows the
heating indicator.
To set the desired temperature:
1. When the screen shows OFF, press the power button for one second. The ROOM indicator is on and the
temperature indication shows room temperature.
2. To increase the desired temperature, press the
the temperature indication shows the temperature to be set. Each time the
temperature increases by 0.5°C.
3. To lower the desired temperature, press the
temperature indication shows the temperature to be set. Each time the
set decreases by 0.5°C.
4. Wait ten seconds after setting the temperature. The ROOM indicator is on. The temperature indication stops
flashing and shows the room temperature. The desired temperature has been set.

4.7.6. Using the child safety lock

The child safety lock can prevent children from accidentally turning on the appliance with the remote control.
To use the child safety lock:
1. To turn on the child safety lock, simultaneously press the
two seconds. The child safety lock indicator is on.
2. To turn the child safety lock off, simultaneously press the
two seconds. The child safety lock indicator is off.

4.7.7. Calibrating the room temperature measurement

If it appears that the room temperature on the screen differs from the actual room temperature, then the room
temperature is not measured correctly. The room temperature measurement can then be calibrated manually.
To manually calibrate the room temperature measurement:
1. When the screen shows OFF, press the power button on the remote control for one second. The ROOM
indicator is on and the temperature indication shows room temperature.
2. Press the Menu button for two seconds. The temperature indication flashes and shows the set calibration value.
+
3. Press the button or the
NOTE
The room temperature measurement can be adjusted down to 5°C and up to 5°C by calibration, in steps
of 0.5°C.
4. Wait ten seconds or press the Menu button for two seconds. The menu closes and the room temperature has
been adjusted.
USER MANUAL
+
button one or more times. The SET indicator flashes and
-
button one or more times. The SET indicator flashes and the
-
button to adjust the room temperature calibration value.
+
button is pressed, the desired
-
button is pressed, the temperature to be
+
-
button and the button and hold the buttons for
+
-
button and the button and hold the buttons for
53