Maico AS Ex Serie Montageanleitung Seite 6

6 Ambient/operating conditions
Fig. 2: AS 65 Ex – AS 71 Ex
A
AS 20 Ex 242
AS 25 Ex 294
AS 30 Ex 346
AS 35 Ex 396
AS 40 Ex 462
AS 45 Ex 501
AS 50 Ex 548
AS 65 Ex 696
AS 71 Ex 760
6 Ambient/operating conditions
• Ambient temperature -30 °C to +60 °C.
7 Installation
NOTICE Shutter does not close correctly if it
is installed under tension.
In order to guarantee the shutter function, only
mount the shutter on a flat surface.
• Allow sufficient space to the wall or ceiling.
1. Open and align the lamellae of the shutter.
2. Mark the 4 drilling positions of the fixing holes,
drill and insert the dowels.
3. Place the protective grille on the back of the
shutter.
4. Screw the shutter including the protective grille
to the wall with 4 screws.
5. To prevent electrostatic charging and thus en-
sure proper functioning, earth the shutter prop-
erly in accordance with the applicable VDE
guidelines.
6. Run function test.
6
B C D
182 21 209
232 26 258
276 25 309
311 25 359
366 26 422
396 30 462
443 30 505
628 30 655
692 40 720
8 Cleaning
Cleaning is done with a dry cloth if necessary –
frequency depends on environmental conditions
and expected impairments.
To clean, swing the lamellae of the shutter up-
wards. Do not use aggressive, harmful or easily
flammable cleaning agents.
The shutter is maintenance-free.
9 Dismantling, environmentally-
sound disposal
Dismantling may only be undertaken by a trained
specialist.
Do not dispose of old units in the normal house-
hold waste.
Proper disposal avoids detrimental impact on
people and the environment and allows valuable
raw materials to be reused with the least amount
of environmental impact.
1. Separate the components according to mater-
ial groups.
2. Dispose of the components and packaging
materials (cardboard, filling materials, plastics)
via appropriate recycling systems or recycling
centres.
3. Observe the respective country-specific and
local regulations.
Company information
© Maico Elektroapparate-Fabrik GmbH. Trans-
lation of the original operating instructions. Mis-
prints, errors and technical changes are reserved.