Fronius WF25i RD Kurzanleitung Seite 2

Cover WF25i RD / WF 60i RD CMT
WARNING! Work that is carried out incorrectly can cause serious injury or damage. All the work de-
scribed below must only be carried out by trained and qualified personnel. Do not carry out any of the
work described below until you have fully read and understood the following documents:
-this document
-all the operating instructions for the system components, especially the safety rules
-"Safety rules" document (enclosed to the welding torch)
WARNING! An electric shock can be fatal. Before starting work:
-turn power source mains switch to the - O - position
-disconnect the power source from the mains
-ensure that the power source remains disconnected from the mains until all work has been completed.
CAUTION! Welding torch components and coolant that have become hot through use can cause se-
vere burns.
Before commencing any of the work described in these operating instructions, allow all welding torch
components and the coolant to cool to room temperature (+25°C, +77°F).
1
1
1
4
1
3
3/4
(270°)
2
3
TX8
2x
TX8
1
2x
2
2 h *
1
2
1
* Allow to dry for 2 hours before reuse
TX8
2x
2
Loctite 290
0 mm
2x
4
3
TX8
0 -
max. 0,2 Nm