OHAUS Frontier FC5515 Bedienungsanleitung Seite 25

TM
Frontier Centrifuge FC5515/FC5515R
4
5
4.1.4 Signal turn on / off
Proceed as described under point 4.1.2 to enter this program mode and then press the key "Accel/Decel" (5). In
the display "Acc/Dec" (A-2) the word "Service" flashes. Now select the letter "L" with the adjusting knob (1). As a
result, the words "On Sound" appears in the display "RPM | RCF" (4). If you press the key "RPM | RCF" (4) now,
the word "On" flashes and you can switch off the sound with the adjusting knob (1) (See figure 33).
After you have stored the settings (See 4.1.2) you change back to the normal program mode again by switching off
the centrifuge for a short while.
A-1
4
5
4.1.5 Volume pre-selection of sound signal
Proceed as described under point 4.1.2 to enter this program mode and then press the key "Accel/Decel" (5). In
the display "Acc/Dec" (A-2) the word "Service" flashes. Now select the letter "U" with the adjusting knob (1). As a
result, in the display "RPM | RCF" (A-1) the words "Vol=0- 9/Sound" appear. After pressing the key "RPM | RCF"
(4), you can adjust the desired volume between 0 (low) and 9 (loud) with the adjusting knob (1) (See figure 34).
After you have stored the settings (see 4.1.2) you can change back to the normal program mode again by
switching off the centrifuge for a short period.
Figure. 32
A-2
Figure. 33
EN-17
1
1