OHAUS Frontier FC5515 Bedienungsanleitung Seite 13

TM
Frontier Centrifuge FC5515/FC5515R
2.3 Installation
Follow these steps:

Check whether the power supply corresponds with the one specified on the manufacturer's rating label, which
is located on the rear panel.

The line voltage circuit breaker is max. 10 A (type K) slow release for commonly used instruments.

In case of emergency, there must be an emergency switch off installed outside the room in order to disconnect
the power supply from the unit.

Connect the centrifuge to a grounded power receptacle.

Turn the instrument on using the mains power switch.

Open the lid by using the Door Open button.

Remove the transport securing device of the motor.
2.4 Safety precautions during operation

Do not operate the centrifuge in case it is not installed correctly.

Do not lean on the centrifuge during operation.

Do not stay within the 30 cm clearance envelope longer than necessary for operational reasons.

Do not place any potentially hazardous materials within the 30 cm clearance envelope.

Do not operate the centrifuge when disassembled (e.g. without housing).

Do not run the centrifuge when mechanical or electrical components have been tampered with.

Do not use accessories such as rotors and buckets, which are not exclusively approved by OHAUS
Corporation, except commercially available centrifuge tubes made of glass or plastic.

Do not spin extremely corrosive substances, as they may damage or weaken the materials.

Do not operate the centrifuge with rotors or buckets, which show any signs of corrosion or mechanical damage.

The manufacturer is responsible for safety and reliability of the centrifuge, only if:

The unit is operated in accordance with this instruction manual.

Modifications, repairs or other adjustments are performed by authorized personnel and the electrical installation
complies with the relevant electrical code.
EN-5