cecotec Cumbia CREMMAET COMPACTCCINO BLACK Bedienungsanleitung Seite 51

Sealing rings
Sealing rings are included with the coffee machine and brushes for replacing them in case
of wear. When they are replaced, you will notice unwanted coffee or water leaks. To replace
them, you can use any pointed tool to remove the old ones and place the new ones exactly in
the same position.
Cleaning the milk outlet
A metal brush specially designed for cleaning the milk outlet holes is included with the
brewer, the plastic brush, and the sealing rings, as the milk can dry out relatively easily and
clog the spout.
5. TROUBLESHOOTING
In the event of a fall or malfunction, unplug the appliance immediately from the mains socket.
If the appliance experiences a mechanical failure, please contact Cecotec's Technical Support
Service. If the problem persists, contact only authorised technicians, the supplier, or the
dealer.
No. Problem
1 The control
panel display
shows the water
tank icon.
No. Possible cause
1.1 The water tank is empty.
It is necessary to
1.2 calibrate the water level
sensor.
Solution
Fill the water tank and insert
it into the machine.
When the machine is in
standby mode:
1.- Remove the water tank.
2.- Remove the sticker from
the reset button on the
water level sensor located
on the corner of the tank
housing. Then press and
hold the reset button for 6
seconds.
3.- Unplug the coffee
machine.
4.- Plug in and switch on
the brewer after 10 seconds.
Insert the tank once it has
been filled.
CREMMAET COMPACTCCINO BLACK
ENGLISH
51