16. Warning of water shortage in the internal pipeline
17. When the no water in internal pipe icon (FIGURE 5) is lights up on the control panel, it
means that there is a shortage of water in the brewer's internal pipe. Make sure that
there is water in the tank and that it is properly installed. Press the "EXIT" button to
restart the water pump and expel the air accumulated in the internal pipes.
4. CLEANING AND MAINTENANCE
Cleaning/rinse
1. Adjust the height of the coffee spout and place a cup underneath.
2. Touch the rinse button for 3 seconds to start cleaning/rinsing. This function uses about
60 mI of water and ends automatically after cleaning is completed. It is used to remove
possible coffee residues in the pipes.
Dismantling parts for cleaning
Fig. 4
1. Pull the water tank upwards by grasping it at the back and guide it out.
2. Pull the cover on the right side until it is removed.
3. Press the blue arrow at number 3 and pull the brewing unit outwards for cleaning.
4. The drip tray can be removed for cleaning by pulling it outwards. Inside you will see the
coffee grounds and all the coffee residues that have accumulated over time. You can
use the plastic brush to clean everything. Afterwards, dry it before placing it back in the
machine.
ATTENTION: When reinstalling the brewing unit, a snapping noise will be heard; if you do not
hear it, disassemble the unit again and reinsert it.
ATTENTION: Check whether the water tank is at the same level as the top of the machine, so
that it is positioned correctly. If this is not the case, push the water tank down until it clicks
into place.
Daily maintenance
Daily maintenance is important to extend the lifespan of the coffee machine and to always
produce good tasting coffee.
CREMMAET COMPACTCCINO BLACK
ENGLISH
49