Beko BHCB66641BBBHS Bedienungsanleitung Seite 16

Air cleaning mode (for models B and C)
You can use air cleaning mode to eliminate
the odour in your house during a long time
at low level.
1. Touch the Speed 1 key for more than 3
seconds.
ð Air cleaning mode is activated.
The light of the Speed 1 key
flashes when the air cleaning
mode is active.
2. The air cleaning mode will operate at
Speed 1 for 10 minutes in 1 hour and
will stop for 50 minutes. If you do not
switch off the air cleaning mode, it will
remain in operation for 10 minutes, then
stop for 50 minutes in each hour for 24
hours.
When air cleaning mode is active, it
is automatically cancelled at the
touch of any key except lamp key.
Your hood continues to operate at
the function of the key you touch.
Aluminium filter fill warning
The light of Speed 2 key flashes for thirty
seconds after every 100 hours of opera-
tion. Clean the aluminium filters. After
cleaning, the lamp warning of Speed 2 key
does not turn off automatically. This
product continues to show the 30-second
warning when the product switches off
after every operation. When you touch the
Speed 2 key for more than 3 seconds, alu-
minium filter fill warning is reset and the
lamp is turned off.
The warning is not cancelled if the
power is cut when the hood gives
aluminium filter fill warning. When
the power is available, it continues
to warn with the light of Speed 2
key flashing.
If you run the hood at any speed
level with the aluminium filter fill
warning, the warning will not ap-
pear for as long as the hood is run-
ning. When you turn off the hood,
the fill warning starts flashing
again for 30 seconds.
If you turn off the warning without
cleaning the aluminium filter, the
operating time of 100 hours is re-
set and it starts over. At the end of
the next 100 hours, your hood
warns again.
Carbon filter fill warning (for products with
carbon filter)
The light of Speed 2 key flashes for thirty
seconds after every 100 hours of opera-
tion. In this case, you must replace your
carbon filter. Consult an authorized service
for this. After replacement, the lamp warn-
ing of Speed 2 key does not turn off auto-
matically. This product continues to show
the 30-second warning when the product
switches off after every operation. When
you touch the Speed 2 key for more than 3
seconds, carbon filter fill warning is reset
and the lamp is turned off.
The warning is not cancelled if the
power is cut when the hood gives
carbon filter fill warning. When the
power is available, it continues to
warn with the light of Speed 2 key
flashing.
If you run your hood at any speed
level with the carbon filter fill warn-
ing, the warning will not appear for
as long as the hood is running.
When you turn off the hood, the fill
warning starts flashing again for
30 seconds.
EN / 16
EN
DE
FR
NL