Werbung
2.
Verbinden Sie das obere Cockpitkabel (55) mit dem
unteren Cockpitkabel (53) und das obere
Widerstandskabel (22) mit dem unteren
Widerstandskabel (54). Schieben Sie die Konsolensäule
(2) auf den Hauptrahmen (3) und sichern dies mit
6 x M8 x 20mm Inbusschrauben (57), 4 x M8
Unterlegscheiben (79) und 2 x M8 Wellenscheiben (75).
Schieben Sie nun die obere Konsolensäulenabdeckung
(46) nach unten.
55
53
Aufbau / Assembly
55
22
57
75 57
79
79
79
79
75
22 54
55
53
Remove the 6 x M8 x 20mm Allen Bolts (57), 4 x M8
Flat Washers (79) 2 from the front and 1 on each side
and 2 x M8 Curved Washers (75) at the rear from the
Main Frame.
a). Slide the Handlebar Upright Cover (46) over the
bottom of the Handlebar Upright (2). Place the end
of the Tension Control Cable-Upper (22) into the
spring hook of the Lower Tension Cable (54).
b). Pull the Tension Control Cable-Upper upwards
against the spring pressure and push it into the gap on
the metal bracket of the Lower Tension Cable as shown.
d). Connect the Exercise Monitor Upper Sensor Wire
(55) to the Exercise Monitor Lower Sensor Wire (53),
ensuring a tight connection.
e). Carefully lower the Handlebar Upright (2) onto the
Main Frame, loosely fit 6 x M8 x 20mm Allen Bolts (57),
4 x M8 Flat Washers (79) 2 at the front and 1 on each
side and 2 x M8 Curved Washers (75) at the rear
previously removed. Make sure the Handlebar Upright
is aligned correctly and tighten all fittings. Slide the
Handlebar Upright Cover (46) down over the Allen
Bolts onto the top of the main frame side panels.
22
54
Werbung
