Assembling The Glass Elements; Installing Interior Fittings; Installing The Glass Door - Sentiotec Fuji Montageanleitung

Instructions for installation and use

6.5. Assembling the glass elements

Please note that when you install the "glass element with holes for
door hinges", you are defining the direction in which the door opens
(see option 1 and 2) as well as the positioning of the sauna heater.
Install the aluminium profiles.
Position the glass element centrally in the door frame, ensuring straight alignment,
and slide the glass elements to the left and right, respectively, into the grooves
in the corner posts.
Insert the "mounting rail above the door" between the glass elements.
The "element above the glass panel, black" is secured using suspension fittings.

6.6. Installing interior fittings

Install the bench support slats.
Mount the ventilation slide.
Start by placing the upper bench on the bench support slats provided for this
purpose.
Screw the bench foot to the upper angled bench outside the cabin, then move it
into position and screw it to the rear upper bench.
Lay the cables for the lighting and drill a hole (approx. Ø 1 cm) in the rear wall
for each cable.
Route the cables as far as the cabin roof.
Install the lower benches.
Screw the bench foot to the lower angled bench outside the cabin, then move it
into position and screw it to the rear lower bench.

6.7. Installing the glass door

Screw the two door fittings onto the glass element, making sure that they are
straight and that the doors open outward.
The alignment of the fittings is achieved by adjusting / rotating both
plastic inserts.
p. 13/16
EN