Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Voice prompt/indicator description
Indicator description
Status
Charging
Battery is full charge
When the machine fails
Low power
Cleaning mode
When something goes wrong with the machine, the red light is always on, and the voice prompts at the same
time. At this time, move the machine position and turn off the machine, then restart it.
Voice prompts description
When the main machine fails, the home button will be flashing red light or stays on, and voice alarm will be heard.
Please refer to the following table to inquire the cause of the failure.
No.
Voice prompt
Battery is low, please charge
1
the robot vacuum cleaner
The main brush is stuck
2
Caster off the ground
3
Please check if the caster is stuck
4
Please check if the side brush is
5
stuck
Cliff sensor fails
6
Please check if the bumper is
7
stuck
The main machine is stuck
8
9
The laser head is stuck
If the above method does not solve the problem, please try the following:
1. Restart the machine.
2. If the problem cannot be solved by restarting the machine, please send the machine to
the after-sales service center for maintenance.
-27-
Display
Breathing red light
Green light always on
Red light always on
Red light always on
Green light always on
Cause of failure
Solution
Battery below 12V
Charge the machine
The main brush is entangled
Remove the foreign matter
with foreign matter
from the main brush
The machine is lifted during
Put it back on the ground
operation
Caster blocking
Remove foreign matter
Side brush blocking
Remove foreign matter
Clean the cliff sensor with a
The cliff sensor is dirty.
soft cloth
Infrared bumper or
Remove foreign matter
universal caster stuck
Move the machine to
Please move the
another place and then
machine to an open area
restart it.
The laser head is dirty or is
Clean the laser head with a
entangled with foreign matter
wet swab
*
Warm tips
Steps to remove the battery
1. For purpose of environmental protection, user shall dispose this product in compliance with the
current national or regional laws and regulations on disposal of waste electrical and electronic
products, or transfer this product to a local approved recycling/disposal agency.
2. The battery of the robot shall be removed and disposed safely in accordance with the following
procedure only by a qualified full-time engineer of an approved recycling/disposal agency.
Step 1
Unscrew the battery cover with a
Step 3
Remove the battery pack and
re-mount the battery cover.
Battery recycling
Step 2
Disconnect the battery terminal.
Step 4
Transfer the battery pack to a
professional recycling agency.
-28-
Werbung
