Herunterladen Diese Seite drucken

Lionelo Hugo i-Size Bedienungsanleitung Seite 10

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 16
FOLDING OF THE SEAT
1.
Connect the backrest of the seat to the seat with connectors (see fig. 1).
2.
Position the backrest vertically (perpendicular to the seat) (fig. 2).
HEADREST ADJUSTMENT
Pull the headrest adjustment lever and adjust the headrest height (fig. 3). The height of
the headrest should be matched to the height of the child, it should be neither too high
nor too low (fig. 4). The headrest of the car seat should surround the head. It should not
be positioned below (e.g., at neck or shoulder level) or above (e.g., leaving the lower part
of the head without any protection). A properly adjusted headrest secures the lower and
upper parts of the child's head, as well as its sides.
SEAT INSTALLATION
Child height: 100– 150 cm
1.
Place the car seat on the couch of the car.
2.
Press the buttons on the ISOFIX arms and slide them out towards the attachment
points, located in the couch. Push the seat toward them until the arms tighten and
you hear a characteristic click. Tighten the seat by making a left-right movement
toward the backrest to make sure it is pressed as tightly as possible against the car's
bench seat. The indicator on both ISOFIX arms must turn green, any other color
indicates improper anchoring of the ISOFIX arms (fig. 5).
Skip the above point if you are not installing the seat using the ISOFIX system.
3.
Press the seat against the backrest of the couch.
4.
Place the child in the seat and adjust the height of the headrest (see section: Headrest
adjustment).
5.
Pass the shoulder belt through the shoulder belt guide (A in fig. 6), located in the headrest.
Pass the lap belt through the lap belt guide under the armrest. Then pass both belts
under the armrest and fasten them (B in fig. 6) while making sure they are not twisted.
Note! Make sure the seat belts are tight, fit tightly around the child's body and are not
twisted. Make sure the lap belts run low and protect the child's pelvis. The belts should be
tight against the child's body, but should not be too tight and cause discomfort.
Child height: 135– 150 cm
Note! It is recommended to use the car seat with the backrest for as long as possible.
1.
Push the backrest of the seat down (fig. 7), then separate the backrest from the seat.
EN
‑ 10 ‑

Werbung

loading