STIEBEL ELTRON WPM Bedienungsanleitung Seite 23

OPeRATION
Menu
Example: Setting a time program
f Navigate to PROGRAMS / HEATING PROGRAM / HEATING
CIRCUIT 1.
MAIN MENU HEATING CIRCUIT 1
PROGRAMS HEATING PROGRAM
+
MON
-
f Select the period for which you want to set the time program.
You have the following options:
- For each individual day of the week (Monday - Sunday)
- Monday to Friday (Mon - Fri)
- Saturday and Sunday (Sat - Sun)
- The whole week (Mon - Sun)
f Turn the Touch-Wheel clockwise to select another day or a
group of days. Confirm the selection with OK.
MAIN MENU HEATING CIRCUIT 1
PROGRAMS HEATING PROGRAM
You can set three switching time pairs per day or block of days.
The switching time pairs are shown on the display, to the right
of the clock. Each switching time pair consists of a start time and
an end time.
In this example, only one switching time pair has been pro-
grammed. The switching time pairs that are still free are repre-
sented with dashes for the time slots.
f Use the Touch-Wheel to select one of the free switching time
pairs or the switching time pair that you wish to change.
Confirm the selection with OK.
f Use the Touch-Wheel to select the start or end time that you
wish to change. Confirm the selection with OK.
MAIN MENU HEATING CIRCUIT 1
PROGRAMS HEATING PROGRAM
- -:- -
TIME
START
www.stiebel-eltron.com
MONDAY
MENU
07:00 - 20:00
- -:- - - - -:- -
- -:- - - - -:- -
- -:- -
TIME
END
f Set the start or stop time using the Touch-Wheel. Confirm
your entry with OK.
Periods around midnight
Switching time pairs can be programmed only up to 24:00. If you
want to choose periods that extend beyond midnight, you will
need to set an additional switching time pair for the following day.
Example: Assume, for example, you want heating mode to be
enabled from 22:00 for four hours every Wednesday evening. The
time period ends on the following Thursday at 02:00.
f For Wednesday, programme the period 22:00 to 24:00.
f For Thursday, programme the period 00:00 to 02:00.
Deleting switching time pairs
f Use the Touch-Wheel to select the switching time pair you
want to delete. Confirm the selection with OK.
f Select the start time using the Touch-Wheel. Confirm the se-
lection with OK.
f Reset the start time to "--:--" using the Touch-Wheel. Confirm
your entry with OK.
By resetting the start time, the associated end time is automat-
ically reset.
… „ HEATING PROGRAM
Select HEATING PROGRAM to determine the times during which
rooms should be heated to the set comfort value. In the periods in
between, heating takes place to the set ECO value. The times are
determined individually for each available heating circuit.
Note
You can set the set values for each heating circuit under
SETTINGS / HEATING / HEATING CIRCUIT / COMFORT TEM-
PERATURE and ECO TEMPERATURE.
f Under HEATING PROGRAM select the heating circuit for
which you want to specify the times.
… „ DHW PROGRAM
Select DHW PROGRAM to determine the times during which DHW
should be heated to the set comfort value. In the periods in be-
tween, DHW is heated to the set ECO value.
Note
You can adjust the set values under SETTINGS / DHW /
DHW TEMPERATURES / COMFORT TEMPERATURE or ECO
TEMPERATURE.
… „ COOLING PROGRAM
Use the COOLING PROGRAM menu item to select the times during
which cooling to the SET ROOM TEMPERATURE should take place.
In the periods in between, no cooling occurs. The times are deter-
mined individually for the available cooling circuits.
WPM | 23