STIEBEL ELTRON WPM Bedienungsanleitung Seite 17

OPeRATION
Safety
… …„ These symbols show you the software menu level (in
this example level 3).
2. Safety
2.1 Intended use
The appliance is intended for domestic use. It can be used safely
by untrained persons. The appliance can also be used in non-do-
mestic environments, e.g. in small businesses, as long as it is
used in the same way.
Any other use beyond that described shall be deemed inappropri-
ate. Observation of these instructions and of instructions for any
accessories used is also part of the correct use of this appliance.
2.2 Safety instructions
WARNING Injury
!
The appliance may be used by children over 8 years of
age and persons with reduced physical, sensory or men-
tal capabilities or a lack of experience and expertise,
provided that they are supervised or they have been
instructed on how to use the appliance safely and have
understood the potential risks. Children must never play
with the appliance. Children must never clean the ap-
pliance or perform user maintenance unless they are
supervised.
Note
Do not change any system-specific settings at the control
unit. Your qualified contractor has set the control unit
to match the local conditions for your building and your
individual requirements. The system-specific parameters
are protected by a code to prevent unintentional mod-
ification.
The parameters that serve to adapt the device to your
personal requirements are not protected by a code.
f The appliance should only be operated once it is fully in-
stalled and all safety equipment has been fitted.
2.3 Test symbols
See type plate on the appliance.
3. Appliance description
The WPM heat pump manager is responsible for the processes
that control and regulate the heat pump. Using the device, you can
make certain settings and display information on the operation
of the heat pump.
Product name
WPM
www.stiebel-eltron.com
4. Operation
4.1 Controls
1
1 Display
2 "MENU" key
3 Touch-Wheel
4 "OK" key
You control the heat pump with the programming unit of the heat
pump manager. The Touch-Wheel consists of a touch-sensitive
sensor. There is one key on each side. All required appliance func-
tions are controlled and checked with the Touch-Wheel and the
keys.
Note
If you have gloves on, have wet hands or if the program-
ming unit is damp, this impedes recognition of your touch
and the execution of the action you require.
4.1.1 Display
The programming unit display shows the current system status
and provides messages and information.
Start screen
1
2
3
4
1 Date and time
2 Temperature display
3 Operating mode
4 System status picture symbols
Part number
The start screen is divided into four sections. The top field displays
234727
the date and time. In the field below, the outside temperature is
displayed, along with the actual DHW temperature and the ac-
tual return temperature. The third section is for selecting and
displaying the operating modes. In the fourth section, picture
symbols indicate the current system status (see chapter "Opera-
tion / Symbols").
WEDNESDAY 12. APR 17 10:23 TIME
OUTSIDE TEMPERATURE 27.0 °C
ACTUAL WW TEMPERATURE 35.0 °C
ACTUAL RETURN TEMPERATURE 28.0 °C
ECO MODE
MENU OK
2 3
WEDNESDAY 12. APR 17
OUTSIDE TEMPERATURE
ACTUAL WW TEMPERATURE
ACTUAL RETURN TEMPERATURE
ECO MODE
4
10:23 TIME
27.0 °C
35.0 °C
28.0 °C
WPM | 17