STIEBEL ELTRON WPM Bedienungsanleitung Seite 22

OPeRATION
Menu
… „ DHW
… „ COMPRESSOR
… „ SILENT MODE
… „ POWER-OFF
… „ SYSTEM TYPE
… „ I/O CONFIGURATION
… „ EMERGENCY OPERATION
… „ RESET
… „ SENSOR CALIBRATION
… „ UPDATE
5.2 Menu description
Note
The appliance user can set the appliance parameters de-
scribed in these operating instructions.
The remaining appliance parameters are to be found in
the commissioning instructions for the heat pump man-
ager.
Ask your qualified contractor to set the remaining appli-
ance parameters.
„INFO
… „ ENERGY FOOTPRINT
Note
The values displayed for heat amount, power consump-
tion, electricity consumption and efficiency are based on
measured correlations that are specific to each type. The
displayed values are not suitable for billing purposes,
for example.
Additional consumption may be caused by components
which are installed outside the appliance. The displayed
values are primarily used for comparing different periods
of use in order to demonstrate trends in a specific system.
The displayed values are greatly influenced by factors
such as the building, the installation location, the instal-
lation and the environmental conditions prevailing during
the period of analysis.
For technical reasons, some of the displayed values may
be considerably inaccurate.
In this menu, you will find values for electricity consumption, the
amount of heat delivered and efficiency. The displayed values
are calculated on a rolling basis. The period covered is specified.
h Hour
M Month
… …„ ENTIRE SYSTEM
… ……„ AMOUNT OF HEAT
… ………„
HEATING 1–24 h
… ………„ HEATING 1–12 M
… ………„ HEATING 13-24 M
… ………„ COOLING 1–24 h
… ………„ COOLING 1–12 M
… ………„ COOLING 13-24 M
… ………„ DHW 1–24 h
… ………„ DHW 1–12 M
… ………„ DHW 13-24 M
22 | WPM
… ……„ POWER CONSUMPTION
… ………„ HEATING 1–24 h
… ………„ HEATING 1–12 M
… ………„ HEATING 13-24 M
… ………„ COOLING 1–24 h
… ………„ COOLING 1–12 M
… ………„ COOLING 13-24 M
… ………„ DHW 1–24 h
… ………„ DHW 1–12 M
… ………„ DHW 13-24 M
… ……„ EFFICIENCY
… ………„ HEATING 1–24 h
… ………„ HEATING 1–12 M
… ………„ HEATING 13-24 M
… ………„ COOLING 1–24 h
… ………„ COOLING 1–12 M
… ………„ COOLING 13-24 M
… ………„ DHW 1–24 h
… ………„ DHW 1–12 M
… ………„ DHW 13-24 M
„PROGRAMS
Here you can set the times at which the individual programs are
enabled.
… „ HEATING PROGRAM
… …„ HEATING CIRCUIT 1
… …„ HEATING CIRCUIT 2
… …„ HEATING CIRCUIT 3
… …„ HEATING CIRCUIT 4
… …„ HEATING CIRCUIT 5
… „ DHW PROGRAM
… „ PARTY PROGRAM
… …„ HOURS
… „ HOLIDAY PROGRAM
… …„ HOLIDAYS BEGINNING
… …„ HOLIDAYS ENDING
… „ PASTEURISATION PROGRAM
… …„ START TIME
… …„ DAYS
… „ DHW CIRCULATION PROGRAM
… SWIMMING POOL PROGRAM „
… „ SILENT PROGRAM 1
… „ SILENT PROGRAM 2
kWh
MWh
MWh
kWh
MWh
MWh
kWh
MWh
MWh
kWh
MWh
MWh
kWh
MWh
MWh
kWh
MWh
MWh
www.stiebel-eltron.com