Werbung
3. The puncturing unit has been damaged.
——— Send the whipper to iSi or to a service
center.
The decorator tip will not unscrew.
1. The decorator tip was attached too tightly.
——— Screw on the decorator tip so that it
is not too tight, but tight enough to be
secure.
——— "Release the pressure." If the decorator
tip still does not unscrew, contact iSi or
a service center.
2. Interim cleaning has not been carried out
regularly.
——— Interim cleaning needs to be carried out
every 1–2 hours.
——— Hold the bottle with the tip under
potable water and clean the tip in warm
running water.
During operation, gas is leaking through the
dispensing piston or decorator tip.
1. The device was used without an attached tip.
——— Before screwing on the charger, make
sure that the decorator tip is attached to
the dispensing piston.
——— "Release the pressure" and then set-up
the whipper again.
2. The dispensing piston seal has been damaged.
——— The dispensing piston needs to be
replaced and is available as an original
iSi spare part.
During operation, gas is leaking between the
bottle and the head.
1. The head gasket is missing.
——— "Release the pressure" and insert the
head gasket into the head.
2. The head gasket has been damaged.
——— "Release the pressure." The head gasket
needs to be replaced and is available as
an original iSi spare part.
3. The head was not tightened securely.
——— Tighten the head onto the bottle by hand
as per the instructions.
15
EN
Werbung
