Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3. Leave the door open. Protect the floor
from the defrosting water e.g. with a cloth
or a flat vessel.
4. In order to speed up the defrosting
process, place a pot of warm water in the
freezer compartment. In addition, remove
pieces of ice that break away before
defrosting is complete. Use the supplied
ice scraper for this purpose.
5. When defrosting is complete, dry the
interior thoroughly. Keep the ice scraper
for the future use.
6. Switch on the appliance and close the
door.
7. Set the temperature regulator to obtain
the maximum coldness and run the
appliance for at least 3 hours using this
setting.
8. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
8.1 What to do if...
Problem
The appliance does not operate.
The appliance is noisy.
Acoustic or visual alarm is on.
The compressor operates continual‐
ly.
16
ENGLISH
Only after this time put the food back into the
freezer compartment.
7.5 Period of non-operation
When the appliance is not in use for long
period, take the following precautions:
1. Disconnect the appliance from electricity
2. Remove all food.
3. Defrost the appliance.
4. Clean the appliance and all accessories.
5. Leave the doors open to prevent
Possible cause
The appliance is switched off.
The mains plug is not connected to
the mains socket correctly.
There is no voltage in the mains
socket.
The appliance is not supported
properly.
The cabinet has been recently
switched on.
The temperature in the appliance is
too high.
The door is left open.
Temperature is set incorrectly.
Many food products were put in at
the same time.
The room temperature is too high.
supply.
unpleasant smells.
Solution
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical appli‐
ance to the mains socket. Contact a
qualified electrician.
Check if the appliance stands sta‐
ble.
Refer to "High temperature alarm"
or "Door open alarm".
Refer to "High temperature alarm"
or "Door open alarm".
Close the door.
Refer to "Control panel" chapter.
Wait a few hours and then check the
temperature again.
Refer to "Installation" chapter.
Werbung
