Electrolux IK2620BL Benutzerinformation Seite 8

Overall dimensions ¹
H1 mm
W1 mm
D1 mm
¹ the height, width and depth of the appliance
without the handle
Space required in use ²
H2 (A+B) mm
W2 mm
D2 mm
A mm
B mm
² the height, width and depth of the appliance
including the handle, plus the space
necessary for free circulation of the cooling
air
Overall space required in use ³
H3 (A+B) mm
W3 mm
D3 mm
³ the height, width and depth of the appliance
including the handle, plus the space
necessary for free circulation of the cooling
air, plus the space necessary to allow door
opening to the minimum angle permitting
removal of all internal equipment
3.2 Location
To ensure appliance's best functionality, you
should not install the appliance in a place with
direct sunlight. Do not install the appliance
close to radiators or cookers, ovens, or hobs,
unless otherwise specified in the installation
instructions.
Make sure that air can circulate freely around
the back of the cabinet.
This appliance should be installed in a dry,
well ventilated indoor position.
8 ENGLISH
This appliance is intended to be used at
ambient temperature ranging from 10°C to
43°C.
1769
557
The correct operation of the appliance
549
can only be guaranteed within the
specified temperature range.
If you have any doubts regarding where
to install the appliance, please turn to the
1816
vendor, to our customer service or to the
nearest Authorised Service Centre.
560
551
1780
It must be possible to disconnect the
appliance from the mains power supply.
36
The plug must therefore be easily
accessible after installation.
3.3 Electrical connection
• Before plugging in, ensure that the voltage
1816
• The appliance must be earthed. The
779
1085
• The manufacturer declines all
3.4 Ventilation requirements
The airflow behind the appliance must be
sufficient.
and frequency shown on the rating plate
correspond to your domestic power
supply.
power supply cable plug is provided with a
contact for this purpose. If the domestic
power supply socket is not earthed,
connect the appliance to a separate earth
in compliance with current regulations,
consulting a qualified electrician.
responsibility if the above safety
precautions are not observed.